Nintendo Switch HAC-003 Replacement Battery — 4310mAh 16Wh — Fits Switch & Switch OLED
This is a brand-new AMPLUS replacement battery for the Nintendo Switch. AMPLUS stands for Aftermarket Plus. The part number is HAC-003. Capacity is 4310mAh at 16 watt-hours. Nominal voltage is 3.7 volts. It fits the original Switch and the Switch OLED. It ships 0-cycle, so it has never been charged. Grade A+ cells sit behind a built-in safety IC. A pre-cut adhesive strip is included in the box. The battery carries a 12-month warranty.
Is Your Switch Battery Failing?
Batteries fade after a few hundred charge cycles. Watch for these signs.
A full charge only lasts an hour or two.
The charge sticks below 100 percent.
It powers off with charge still showing.
The reading leaps from 50 to 0 percent.
It only runs while plugged into power.
The back cover bulges or lifts. Replace it now.
Backed By A 12-Month Warranty
This AMPLUS battery is covered for 12 months against defects from the date of purchase.
Brisbane Technical Hub
Based locally at Shop 3A, 152 Woogaroo St, Forest Lake QLD 4078. Bench fitting available over the counter.
Authenticity Guaranteed
Genuine AMPLUS cells from verified suppliers. Every battery is bench inspected before dispatch.
Reliable Dispatch
Orders ship in 2-4 business days from Forest Lake. Tracked Australia Post on every order. Australia-wide delivery.
Why Choose AMPLUS Grade
AMPLUS stands for Aftermarket Plus. It sits above generic clones, below genuine Nintendo.
Full 4310mAh Capacity
It matches the original 16Wh spec. No watered-down capacity here.
Grade A+ Cells
Fresh 0-cycle cells hold charge better than cheap clones.
Built-In Safety IC
Guards against overcharge, overheating, and short circuits.
Honest Aftermarket Grade
We never call it genuine Nintendo. It is quality aftermarket.
Confirm It Is The Battery First
Run these checks before you order. They point to a worn battery.
- A full charge drains far faster than it used to.
- The charge level stops climbing before 100 percent.
- The console shuts down with charge still showing.
- The percentage jumps or drops in big steps.
- The back cover bulges from a swollen cell.
- The Switch still charges and boots on the dock.
- A working dock rules out a dead charge port.
- The console is a few years old with heavy use.
Install Notes — Read Before Fitting
- Power off the console fully before you open the back.
- The back cover uses Y00 tri-point screws. Use the right bit.
- Inner shields use JIS 000 screws. Keep screws in order.
- Warm the old battery adhesive to lift it safely.
- Never pry a swollen battery hard. Lift it slowly and evenly.
- Do not puncture or bend the cell. Damaged cells can catch fire.
- Fit the pre-cut adhesive strip before seating the new battery.
- Use an anti-static strap to protect the board.
This is a moderate repair. Book our Forest Lake bench if you are unsure.
Tools You Will Need
Removes the four back-cover tri-point screws.
Removes the inner shield and bracket screws.
Unplugs the battery connector without a spark.
Slides under the old battery adhesive.
Handles small screws and the connector flex.
Softens the adhesive under the old cell.
Full Specifications
Compatibility — Fits and Does Not Fit
Check your console model on the back near the serial number.
Switch Lite (HDH-001) — uses the smaller HDH-003 battery. Shop our Switch parts range for the Lite cell.
Joy-Con controllers — they use separate internal cells, not this battery.
AMPLUS Battery vs Cheap Clone
Full 4310mAh with fresh 0-cycle cells.
Built-in safety IC and CE plus RoHS marks.
Backed by a 12-month warranty.
Often rates below the real 4310mAh mark.
May skip proper safety protection circuits.
Usually sold with little or no warranty.
Book A Bench Fitting In-Store
Shop 3A, 152 Woogaroo St, Forest Lake QLD 4078.
Local Forest Lake bench for Switch battery swaps.
Genuine AMPLUS cells, bench inspected.
Tracked dispatch in 2-4 business days, Australia-wide.
Shipping & Delivery
- Dispatch: Orders ship in 2-4 business days from Forest Lake QLD.
- Brisbane Metro: Usually 1-2 days after dispatch.
- Sydney & Melbourne: Usually 3-5 days after dispatch.
- Perth & Regional: Usually 5-8 days after dispatch.
- Tracking: A tracked Australia Post number is sent on dispatch.
- Pickup: Click and collect from Shop 3A, 152 Woogaroo St, Forest Lake QLD 4078.
Pay your way — Afterpay and Klarna available at checkout.
Frequently Asked Questions
Browse More Switch Parts
Explore batteries, screens, and repair tools in the full range.
Pay your way — Afterpay and Klarna available at checkout.
JPC Mobile — Nintendo Switch Repair Parts Specialist, Forest Lake Brisbane
AMPLUS Switch batteries dispatched from Forest Lake QLD. Australia-wide tracked shipping.
Available online and in-store at Shop 3A, 152 Woogaroo St, Forest Lake QLD 4078.
Payment Options
We offer multiple convenient payment options for your repairs and accessories purchases. Pay with cash, debit/credit card, or interest-free Buy Now Pay Later options.
Shipping & Processing Information
Processing Time
All orders require 2-4 business days for processing, regardless of shipping method.
This includes order verification, picking, packing and preparation for dispatch.
You will receive tracking information for all shipped orders and notification when pickup orders are ready for collection.
Shipping Methods
Standard: 3-7 business days in transit after processing
Express: 1-2 business days in transit after processing
Express shipping only affects delivery time once dispatched, not processing time.
Express shipping does not expedite the 2-4 business day processing time.